WEG CFW100040SDPLZ VFD C10014 - 230 VAC - 1 Phase Input 230V 3 Phase 4 Amp 1 HP Output

TEMCo ID | C10014 |
---|---|
Manufacturer Part Number | CFW100040SDPLZ |
Input Voltage | 230 VAC - Single Phase |
Input Voltage | 240 |
Horsepower (CT) | 1 |
Amps (CT - Single Phase Input) | 4 |
Output Phase | Three |
Output Voltage | 230 |
Output Voltage | 240 |
Enclosure Rating | IP20 |
Programmable Digital Inputs | 4 |
Programmable Analog Inputs | 1 |
Programmable Relay Outputs | 1 |
Agency Approvals | CE Marked |
Length (in) | 4.8 |
Width (in) | 3.8 |
Height (in) | 5.2 |
Weight (lb) | 2 |
Shipping Weight (lb) | 3 |
Warranty | 18 Months |
The WEG Digital CFW10 VFD Series is a very small, easily mounted package, simplified keypad and bright LED readout, complete diagnostics and fully programmable I/O. The CFW10 controls three phase AC motors with a single phase AC input. Single phase 120 VAC input voltage will produce three phase 230V to drive motors up to 1 HP and single phase 230 VAC will produce three phase 230V to drive motors up to 3 HP. Increased flexibility and decreased costs are achieved by eliminating the need for a step-up transformer to operate three phase 230 VAC motors when only single phase 115V is available. The CFW10 is an economical solution to many industrial and commercial applications.
Standard Features
- Same programming as other WEG VFDs
- V/Hz control
- IP20 finger safe enclosure
- Single Phase 110-120 VAC input voltage up to 1 HP
- Single Phase 200-240 VAC input voltage up to 3 HP
- 150% current overload capacity
- 2.5-15 kHz adjustable switching frequency
- Four isolated programmable digital inputs (12 VDC)
- Programmable relay output (250 VAC 0.5A/125 VAC 1.0A or 30 VDC 2.0A)
- One isolated programmable analog input (0-10V 0/4-20mA)
- Diagnostic features: Over current, motor overload, drive over temperature, output short circuit, DC bus over and under voltage and external fault
- Control features: Linear and S-Ramp acceleration and deceleration, local / remote control, DC braking, torque boost, motor slip compensation, electronic pot, preset speeds, minimum and maximum adjustable frequency limits, adjustable output current limit, JOG, PID Controller
- Display readings: Motor speed, frequency, voltage, current, last fault, heatsink temperature and drive status
- Ambient: 122°F (50°C), 3300 ft (1000 m) altitude, 90% humidity, non-condensing

VFD Speed Control - WEG CFW 10 Setup
Learn how to program speed control on a WEG CFW10 variable frequency drive.